VBrick Systems VB6000 Series Manuel d'instructions télécharger pdf (Page 37)

Passthrough State: Initiator

Operational State Describes the current status of a Passthrough connection, including

error conditions, if any. Refer to the Monitor > Network

page. This

will display "Active" if in Passthrough mode.

Passthrough State Initiator – In this case it will continuously attempt to automatically

initiate a Passthrough connection to the remote destination. This

mode also offers metadata destination options.

Destination Read-only: Dedicated.

Dedicated Destination The VBrick appliance (whose serial port is the destination of this

COM port) can be configured and identified using either an IP

address or a host name.

Dedicated Port Default - 4439.

Baud Rate Rate of Passthrough port. Rate can be set to the following (Default

= 9600): 110, 300, 600, 1200, 2400, 3600, 4800, 7200, 9600, 14400,

19200, 28800, 38400, 57600, 115200.

Stop Bits Number of stop bits for Passthrough port (1 or 2).

Parity None, Even, Odd.

RTS Control Force OFF, Force ON or Automatic. If automatic, the control will

be on when Passthrough is active.

Note: DTR and RTS are not available for COM. Under no

conditions are RTS or DTR controls passed through end-to-end.

All control handling is local.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 84 85

Pas de commentaire

VBrick Systems VB6000 Series Manuel d'instructions Page 37